The Short Answer
Cover the top, leave the sides open. A top cover keeps rain and snow off, and open sides let wind carry moisture away. That combination dries wood fastest and keeps seasoned wood dry.
What you shouldn't do is wrap the whole pile in a tarp. It traps moisture coming off the wood, and condensation collects on the inside. Wood under a fully wrapped tarp often ends up damp and moldy.
Covered vs. Uncovered vs. Fully Wrapped
| Setup | Drying speed | Stays dry in rain | Verdict |
|---|---|---|---|
| Top covered, sides open | Fast | Yes | Best for most people |
| Uncovered | Fast in dry weather | No | Fine in dry climates or a dry summer |
| Fully wrapped in a tarp | Slow | Mostly, but holds moisture in | Avoid |
| Closed shed with no airflow | Slow | Yes | Only for wood that's already dry |
When Uncovered Is Fine
Leaving a stack uncovered isn't a disaster. Rain wets the outside of the wood, and in a dry, sunny climate it dries again quickly. Some people leave freshly split green wood uncovered through its first summer so sun hits every surface, then cover the top before the fall rains.
Uncovered stacks struggle in wet climates, in winter, and anywhere snow sits on the pile. The top rows stay wet the longest, and wood that stays wet for weeks starts to rot.
When to Cover Firewood
- Before the rainy season in your area, or before winter, whichever comes first.
- Always, once wood is seasoned. There's no point letting dry wood soak up water again.
- Anywhere it snows. Snow melts into the stack.
How to Cover It Right
- Top only. Let the cover hang down a few inches over the sides, not to the ground.
- Weigh it down with a few splits or bungees so wind doesn't strip it off.
- Use something that sheds water: a tarp folded to fit the top, a sheet of metal roofing, plywood, or a purpose-made stack cover.
- Slope it if you can, so water runs off instead of pooling.
- Bark side up on the top row helps shed water too.
How to Secure a Tarp Over Firewood
- Size it to the top. Pick a tarp that covers the top of the stack with 6 to 12 inches hanging over each side. Fold any extra rather than letting it reach the ground.
- Make a ridge. Lay a long 2x4 or a pole along the top of the stack before the tarp goes on, so the tarp forms a peak and water runs off instead of pooling.
- Weigh it down. Set a few splits or a board along each edge on top of the tarp.
- Tie it off. Run bungee cords from the grommets to the rack ends, or to stakes, keeping the sides open below the overhang.
- Check it after storms. Re-tighten anything wind has loosened and tip off pooled water.
Firewood Cover Ideas
- A metal roofing panel laid across the top, weighted with a few splits. Sheds water and lasts for years.
- Plywood with a shingle or roll roofing top, cut to fit a rack.
- A purpose-made rack cover that covers the top and only the top third or so of the sides.
- A small roof built onto the rack. See our DIY firewood rack with a roof.
- An overhang or lean-to against a fence or outbuilding.
Better Than a Tarp: A Roof
A rack with a built-in roof or an open-sided shed does the same job without the flapping tarp. See firewood shed ideas and our firewood holder ideas for options, and how to stack and store firewood for where to put it.